GHOST π with 2 x 1 Gbit transmit ports - F.O. dual opticalCON Neutrik - single-mode (on the front panel) and internal redundant power supply.
Connectivity & Interface
Front panel | 8 x 10 Base-T / 100 Base-TX / 1000 Base-T etherCON PoE+ ports 2 x 10 Base-T / 100 Base-TX / 1000 Base-T etherCON ports 2 x 10 Base-T / 100 Base-TX / 1000 Base-T opticalCON DUAL ports 8 x 8 caracters LCD sceens 3 LEDs (Status, traffic, ID) on each etherCON port 2 LEDs (Tx Rx) on each opticalCON port 1 x configuration and navigation function switch |
Rear panel | 4 x 10 Base-T / 100 Base-TX / 1000 Base-T etherCON PoE+ ports 1 x remote and control RJ45 port 2 x power cord (redundant internal power supply) |
Software | Telnet protocols for up to 100 devices connected Offline editor mode Service and maintenance window |
Processing
Motherboard | 1 x ARM9E: 800 MHz 256 MB DDR3 SDRAM 128 MB flash memory Data flow: up to 41.6 Mbps Switching capacity: 56 Gb/s Memory flash: 128 MB |
Network | 99 x groups available 1 6000 MAC Address capacity Power Over Ethernet IEEE802.3at IEEE 802.1p traffic priority |
Package
Package includes | 1 x GHOST engine 1 x power cord IEC13 Lock 1 x Start configuration guide 1 x USB key with Software, firmware and owner‚ documents |
General
Size (W x D x H) (mm) | 442 x 481 x 44.5 |
Weight (without options) | 4.05 kg |
Power consumption | 100 - 127 VAC 3.2 A, 200 - 240 VAC 1.6 A |
Power supply | 120 - 230 VAC 50/60 Hz |
Idle power* | 25.2 W |
PoE power available** | 195 W |
Allocated power (per port)** | 1-33 W |
Maximum power rating*** | 247 W |
Storage temperature / humidity | -40 °C to - 70 °C / 15 to 90% with condensation |
Operating temperature / humidity | 0 °C to 45 °C / 15 to 95% with condensation |
Altitude | Up to 10,000 ft (3 km) |
Acoustic | 43.9 dB |
* Idle power is the actual power consumption of the device with no ports connected
** PoE power is the total power budget available to all PoE ports
*** Maximum power rating and maximum heat dissipation are the worst-case theoretical maximum numbers provided for planning the infrastructure with fully loaded PoE (if equipped), 100% traffic, all ports plugged in, and all modules populated