All-in-one controller integrating video processing and control
The VX1000 is NovaStar's new all-in-one controller that integrates video processing and control into one device. The presence of 10 output Ethernet ports provides a loading capacity of 6.5 M pixels. A single unit can handle 10,240 pixels wide x 8192 pixels high image. 4K x 1K @ 60 Hz high resolution input, 4K x 1K dot to dot display: high quality 4K image with 3 layers and free scaling for each layer! In terms of connections, the VX1000 has 2 HDMI 1.4 inputs, 2 x DVI and a 3D-SDI input. There are also 2 optical ports for long distance video signal transmission. A single processor allows three modes of operation with free switching between them: Video Controller, ByPass and Fiber Converter. Finally, for maximum stability, there is a complete system of redundancy: support for redundant input sources, system configuration, Ethernet ports and devices. With 10 customizable presets and a latency of just 1 frame, this powerful controller can be widely used in applications such as mid-range and high-end rental, stage control systems and fine-pitch LEDs screen.
Input Connectors
3G-SDI:
ST-424 (3G), ST-292 (HD) and ST-259 (SD) standard video inputs supported
Max. input resolution: 1920×1080 @ 60 Hz
Deinterlacing processing supported
3G-SDI loop output supported
DOES NOT support input resolution and bit depth settings
Max. height: 8192 pixels Ethernet ports 1 and 2 support audio output. When you use a multifunction card to parse the audio, be sure to connect the card to Ethernet port 1 or 2
HDMI 1.3
Support monitor and video output modes.
The output resolution is adjustable
OPT X2: 10G optical fiber ports
OPT 1: Self-adaptive, either for video input or for output
When the device is connected with a fiber converter, the port is used as an output connector.
When the device is connected with a video processor, the port is used as an input connector.
Max. capacity: 1x 4K×1K @ 60 Hz or 2x 2K×1K @ 60 Hz video inputs
OPT 2: For output only, with copy and backup modes
OPT 2 copies or backs up the output on 10 Ethernet ports
ETHERNET: Connect to the control PC or router.
USB X2:
USB 2.0 (Type-B):
Connect to the control PC.
Input connector for device cascading
USB 2.0 (Type-A): Output connector for device cascading
GENLOCK IN-LOOP: Connect to an external sync signal. Accepts bi-level and tri-level signals.